Zoning glossary

What Is a Future Land Use Map? FLUM Designations Explained

What a future land use map is, what a future land use designation controls, how the map differs from the zoning map, and how Tampa, Orange County, Pinellas County, Phoenix, and Austin publish theirs.

By Nathan Robinson, Founder, Plotzy Published 7 min read

A future land use map, often shortened to FLUM, is the map in a city's or county's comprehensive plan that shows what each area is planned to become. Every parcel gets a future land use designation, such as low density residential, mixed use, commercial, or industrial, and each designation comes with a range of allowed uses and a ceiling on density and intensity. The zoning map then has to fit inside that ceiling, which is why the FLUM often decides how far a rezoning can go.

How it works

A comprehensive plan has written policies and a map. The map applies the policies to the ground. In Florida, state law makes the map mandatory: section 163.3177(6)(a) requires a future land use element that designates the future general distribution, location, and extent of uses such as residential, commercial, industry, agriculture, recreation, and conservation. Each category must be defined by the uses it includes and by standards for population density and building intensity, and the categories must be shown on a land use map or map series.

Two numbers usually define a category:

  • Density: the number of residential units allowed per acre. Florida defines density in section 163.3164 as an objective measurement of the number of people or residential units allowed per unit of land.
  • Intensity: how much nonresidential building is allowed, usually expressed as floor area ratio.

The FLUM is a plan, not a regulation of the parcel's day-to-day use. Zoning still sets the specific district, setbacks, height, and permitted uses. But in a state with a consistency rule, such as Florida, zoning and development approvals must be consistent with the plan, so a rezoning that exceeds the designation needs a plan amendment first. The future land use vs. zoning guide covers that relationship in detail.

What a designation tells you

The label alone often carries the key number. Real examples from current plans:

JurisdictionDesignationCeiling
City of TampaR-10 Residential10 units per acre
City of TampaUMU-60 Urban Mixed Use60 units per acre, 3.25 FAR
City of TampaRMU-100 Regional Mixed Use100 units per acre, 3.5 FAR
Orange CountyLDR Low Density Residential0 to 4 units per acre
Orange CountyHDR High Density Residential0 to 50 units per acre, plus bonuses
Orange CountyCommercial1.50 FAR
Unincorporated Pinellas CountyRH Residential High30 units per acre
PhoenixTraditional Lot 3.5 to 53.5 to 5 units per acre

In Tampa, the number in the code is the maximum units per acre. That is a common source of confusion: Tampa's future land use "R-10" looks like a zoning district, but the city's zoning districts use RS and RM families. Always check which layer a label belongs to.

Names for the same idea

What it can be used for today

Check a parcel's current zoning

The future land use map shows where a city is headed. Zoning decides what you can build now. Zoning AI reads the ordinance for a specific parcel and answers questions about permitted uses, setbacks, FAR, height, or parking, with the section it came from.

  • Plain-English answers with section-level citations
  • Filter parcels by zoning before you spend a day on due diligence
  • Owner, lot size, and last sale next to the zone
See Zoning AI

Free trial

"FLUM" is mostly a Florida term, used across the state because of the statutory requirement. Elsewhere the same map goes by other names:

  • Phoenix calls it the General Plan Land Use Map, part of the general plan.
  • Detroit calls it Future General Land Use, part of its Master Plan of Policies.
  • Place types maps are the newer format. Orange County's Vision 2050, Austin's coming citywide map, and the Plan Detroit draft all organize the future map around place types, such as urban center or suburban neighborhood, rather than single use categories.

What it means if you are buying or developing land

  • Yield: the designation caps units and floor area. A parcel zoned for less than its designation allows may be upzoned with only a rezoning. A parcel already at its ceiling needs a plan amendment to go higher.
  • Time: a future land use amendment adds its own hearings and, for larger changes in Florida, a state review step. See Florida comprehensive plan amendments for thresholds and timelines.
  • Risk: plan maps change during rewrites. Tampa, Orange County, Austin, and Detroit are all mid rewrite, so a designation can shift between contract and closing.
  • Opportunity: a newly adopted designation that allows more than current zoning signals where a rezoning is likely to be supported.

How real jurisdictions handle it

Other city pages cover Hillsborough County, Orlando, Miami, Fort Lauderdale, Cape Coral, and Detroit. The future land use hub lists them all.

How to check a specific parcel

  1. Find who plans for the parcel. A city address can sit in an unincorporated county, which has a different plan and map.
  2. Open the official FLUM viewer, not a PDF found by search. Older map copies often outrank the current one. In Tampa and Hillsborough County, archived Plan Hillsborough copies still rank high.
  3. Note the designation, then read its definition in the plan text for uses, density, intensity, and any requirement such as a planned development rezoning.
  4. Compare it with the zoning district. If the use or density you want is above the designation, budget for a plan amendment. The zoning lookup guide covers the zoning side.
  5. Check for pending plan amendments and rewrites that could change the designation.

Frequently asked questions

What does FLUM stand for?

FLUM stands for future land use map. It is the map in a comprehensive plan that assigns each parcel a future land use designation. The term is used most in Florida, where state law requires every local plan to include one.

Is a future land use designation the same as zoning?

No. The designation is a plan category that sets the general use and the maximum density and intensity. Zoning is the regulation that sets the specific district rules. In Florida, zoning must be consistent with the designation, so the designation acts as a ceiling on what zoning can allow.

Can a future land use designation be changed?

Yes, through a comprehensive plan amendment adopted by the city council or county commission. In Florida, a map change of 50 acres or fewer can usually go through the small-scale process with one adoption hearing, while larger changes need two hearings and state review.

Where do I find the future land use map for a property?

Start with the planning department of the city or county that has jurisdiction. Most publish an interactive viewer that shows the designation by address, plus the plan text that defines each category.

Sources

The statutes, plans, maps, and agency documents cited on this page were checked on November 15, 2026. Plans and maps are amended often, so confirm the current version before relying on any detail. This page is general information, not legal advice.

Related reading